Pursuant to section 166(3) of the Land Transport Act 1998, the NZ Transport Agency gives notice that the following exemptions from the stated Land Transport Rules were granted under section 166(1) of that Act between 1 January 2019 and 31 March 2019:
Nature of exemption |
Number of exemptions |
Driver Licensing 1999 (Rule 91001)
Clause 7—class of licence required for class of vehicle |
2 |
Clause 15(b)—requirements to obtain learner licence |
34 |
Clause 17(b)—requirements to obtain restricted licence |
62 |
Clause 18—conditions of restricted licence |
147 |
Clause 19(b)— requirements to obtain full licence |
28 |
Clause 27(1)(b)—person has held a New Zealand full licence for at least 2 years before obtaining passenger endorsement |
204 |
Clause 29(c)—person has successfully completed approved course before obtaining special-type endorsement |
37 |
Clause 38(2)—minimum visual acuity to obtain driver licence or endorsement |
9 |
Clause 89(2)(c)—overseas driver licence conversion: practical driving test |
24 |
Clause 89(2)(d)—overseas driver licence conversion: production of overseas driver licence |
32 |
Glazing, Windscreen Wipe and Wash, and Mirrors 1999 (Rule 32012)
Clause 5.2(1)—motor vehicle must be fitted with one or more compliant rear-view mirrors |
1 |
Heavy Vehicles 2004 (Rule 31002)
Clause 4.4(5)—towbar fitted after 1 April 2006 must comply with certain standard |
1 |
Clause 4.6(3)—hook-type, pin-type, or ball-and-socket type coupling must comply with certain standard |
1 |
Clause 4.7(1)—fifth-wheel assembly |
1 |
Clause 6.4(3)—modification to chassis of vehicle must be designed to certain stress levels |
4 |
Heavy-vehicle Brakes 2006 (Rule 32015)
Clause 2.3(9)—parking brake must be able to be applied by driver from normal driving position using one control only |
1 |
Clause 2.5(1)—approved vehicle standards for brakes |
4 |
Clause 8.1(4)—brake performance must be checked and modified to comply with Rule if vehicle is modified |
4 |
Schedule 5—New Zealand Heavy-vehicle Brake Specification |
3 |
Light-vehicle Brakes 2002 (Rule 32014)
Clause 2.1(3)—requirement for certain vehicles to have electronic stability control system |
1 |
Clause 2.3(12)—certain vehicles must comply with parking break requirements |
12 |
Clause 2.3(13)—parking brake must act on at least one complete axle |
12 |
Clause 2.3(14)—parking brake must meet certain performance criteria |
12 |
Clause 2.4(5)—brakes on light trailer with laden weight of 2500kg or more |
252 |
Clause 2.5(1)—approved vehicle standards for brakes |
2 |
Operator Licensing 2017 (Rule 81001)
Clause 3.2(1)—requirement to display current driver identification card when operating small passenger service vehicle |
20 |
Passenger Service Vehicles 1999 (Rule 31001)
Clause 4.1(3)—shoulder-room width |
6 |
Clause 6.14(2)—side walls of open-bodied part of passenger service vehicle must extend at least 450mm above the highest point of the uncompressed seat cushion |
1 |
Seatbelts and Seatbelt Anchorages 2002 (Rule 32011)
Clause 2.3—general safety requirements for seatbelt anchorages |
1 |
Clause 2.7(2)—approved vehicle standards for seatbelt anchorages fitted as original equipment |
1 |
Clause 4.2—repair and replacement of seatbelts and seatbelt anchorages |
1 |
Steering Systems 2001 (Rule 32003)
Clause 2.5—left-hand drive vehicles |
3 |
Traffic Control Devices 2004 (Rule 54002)
Clause 6.3(1)—standard requirements for traffic display signals |
1 |
Tyres and Wheels 2001 (Rule 32013)
Clause 2.3(1)—tyres on the same axle must be of the same size designation and construction |
7 |
Vehicle Dimensions and Mass 2016 (Rule 41001)
Clause 3.2(1)—vehicle must comply with applicable dimension requirements |
1 |
Clause 3.13—trailer must be of a certain type |
10 |
Clause 3.14—tow spacing |
10 |
Clause 4.4—axle mass limits |
10 |
Clause 4.5—mass ratio of towed and towing vehicles for heavy combination vehicles |
10 |
Clause 5.1(1)—motor vehicle requires permit to exceed mass limits |
4 |
Clause 6.35(1)—minimum piloting requirements for Category 3 and Category 4 vehicles and loads |
1 |
Clause 6.41(5)—Class 1 pilot vehicles must meet certain requirements |
1 |
Part 2, definition of tri-axle set—centres of first and last axles must be spaced not less than 2.0 metres apart |
2 |
Vehicle Exhaust Emissions 2007 (Rule 33001)
Clause 2.2(1)—vehicle must comply with approved vehicle emissions standard or a higher standard |
153 |
Clause 2.2(2)—vehicle used exclusively by NZ Defence Force may be fitted with a defeat device |
1 |
Clause 2.2(3)—vehicles to which vehicle emission standards in clause 2.2 do not apply |
1 |
Vehicle Lighting 2004 (Rule 32005)
Clause 4.3(5)—certain vehicles must have one or two pairs of stop lamps |
1 |
Clause 7.4(4)(a)—certain vehicles must be fitted with one or two pairs of rearward-facing position lamp emitting light visible from certain distances |
1 |
Clause 8.3(2)—certain registered motor vehicles must be fitted with rear registration-plate illumination lamp |
1 |
Clause 9.3(4)—certain registered motor vehicles must be fitted with rearward-facing retroreflectors |
1 |
Vehicle Standards Compliance 2002 (Rule 35001)
Clause 4.2—inspection requirements |
29 |
Clause 4.3—information to be recorded |
29 |